Table of Contents
Advertisement
Selects a baud rate that is identical with your computer' s so that you can connect
Baud Rate
the projector using a suitable RS-232 cable and update or download the projector' s
firmware. This function is intended for qualified service personnel.
Adjusts the equalizer gain settings for an HDM I signal. The higher the setting, the
HDMI
stronger the gain value. If there are more than one HDM I port on the projector,
Equalizer
select the HDM I port first before adjusting the value.
USB Power
Disables or enables — Type A connector" to output 5V power manually.
Switch
Returns all of the adjustments you' ve made for the Settings menu to the factory
Reset Settings
preset values.
System
Language
Sets the language for the On-Screen Display (OS D) menus.
• Network:
Standby
Settings
This function is only available when E nable Network S tandby M ode is On.
• Microphone: E nables the microphone line-out function when the projector is in
• Monitor Out: Allows the projector to output a V GA signal when it is in standby
• Audio Pass Through: The projector can play sound when it is in standby mode
•
Background
• Splash
Settings
• Menu Type: Switches to the Basic OSD menu.
Menu Settings
• Menu Display Time: Sets the length of time the OSD will remain active after
• Enable Network Standby Mode: Selecting On enables the function. The
projector is able to provide the network function in standby mode. Selecting
Off disables the function. The projector does not provide the network
function in standby mode.
• Switch to Normal Standby Mode: Allows the projector to disable the
network function after a set period of time after it enters standby mode. For
instance, if 20 min is selected, the projector is able to provide the network
function for 20 minutes after it enters standby mode. When 20 minutes is up,
the projector enters normal standby mode.
standby mode.
mode and the PC jack and the MONITOR OUT jack are correctly connected to
devices.
and the corresponding jacks are correctly connected to devices. Press
choose the source that you wish to use. See
make the connection.
Background:
Sets the background color for the projector.
Screen:
Allows you to select which logo screen will be displayed during
projector start-up.
your last key press.
Connection on page 18
/
to
for how to
M enu operation
35
Advertisement
Table of Contents
