Table of Contents
Advertisement
Enable the Radio
In countries with laws and regulations that permit wireless communications, wireless communication protocols
are available to expand the capabilities of the Imager. All Imagers ship from the factory with the radios disabled.
To enable the radio:
1. On the Imager, select Camera > Fluke Connect.
2. On the PC, go to http://fluke.com/register/ti.
3. On the website:
a. Select a language from the drop down box.
b. Enter your information and the serial number from the display on the Imager. The serial number is case
sensitive.
c. Click on Submit.
If the radio is authorized in your country, an authorization code appears on the web page.
If the radio is not yet authorized in your country, Fluke will contact you when the radio is authorized for
use in your country.
4. On the Imager,
a. Push
or tap Enter Code.
b. Type in the authorization code from the website. (The authorization code is not case sensitive.)
c. Push
or Done.
A message appears on the Imager display that shows the wireless communication is enabled.
If a message appears that says the authorization code is invalid:
•
Make sure you entered the correct serial number from the Imager into the website.
•
Make sure you entered the correct authorization code from the website into the Imager.
d. Tap Ok.
5. Connect to a wireless device, if desired. See
Streaming Video (Remote Display)
The Imager can stream live infrared and IR-Fusion technology video to a PC that has SmartView software
installed, to the Fluke Connect app (where available), or to an HDMI compatible device.
Professional Series Thermal Imagers
Note
Wireless
Connectivity.
Streaming Video (Remote Display)
39
Advertisement
Table of Contents
