DSC iotega WS901 Reference Manual page 30

Default: 0000 to 65535
Valid range: 0000000000 to FFFFFFFFFF
CMS Ethernet 2 Remote Port
This section is used to program the port number used by Eth-
ernet 1. Set the value of this port when the installation is loc-
ated behind a firewall, and must be assigned a particular
port number as determined by the central monitoring station
system administrator.
Default:
Valid range:
CMS Ethernet 2 Domain Name
This information is provided by the central monitoring station
system administrator.
Default: Blank
Valid range: 32 characters ASCII
CMS Cellular 1 Account Code
The account code is used by the central monitoring station
to distinguish between transmitters. Programming all 0's or
all F's causes a module configuration Trouble.
A cellular account code is necessary in order for the iotega
to communicate to the central monitoring station (if cellular
communication path is selected).
Default: 0000000000
Valid range: 0000000000 to FFFFFFFFFF
CMS Cellular 1 DNIS
The DNIS is used in addition to the account code to identify
the communicator module at the central monitoring station.
Default: 000000
Valid range: 000000 to 0FFFFF
CMS Cellular 1 IP Address
Enter the cellular receiver 1 IP address. This information will
be provided by the central monitoring station system admin-
istrator.
Note: When a valid IP address has been entered, the cel-
lular receiver is enabled and will communicate events over
the cellular channel.
Default: 000.000.000.000
Valid range: 000.000.000.000 to 255.255.255.255
3061 (0BF5)
0000 to 65535
CMS Cellular 1 Remote Port
This section determines the port used by Cellular Receiver 1
for communication to the receiver.
Note: Programming this section with 0000 will disable the
receiver.
Default:
Valid range:
CMS Cellular 1 APN
The Access Point Name (APN) determines the cellular net-
work that the communicator will connect to. This information
is available from the network carrier.
Note: When a SIM card with a custom APN is used, the unit
will not have access to the Internet. DLS and remote flash
can still be done if a valid public APN is programmed.
Default:
Valid range:
CMS Cellular 1 Domain Name
This information is provided by the central monitoring station
system administrator.
Default:
Valid range:
CMS Cellular 2 Account Code
Default: 0 Not in valid range
Valid range: 0000000001 to FFFFFFFFFE
The account code is used by the central monitoring station
to distinguish between different transmitters. This account
code is used when transmitting signals to the central mon-
itoring station receiver.
Note: Programming this section as all 0's or F's will cause a
module configuration trouble (yellow LED = 12 flashes).
Note: A cellular account code is necessary in order for the
iotega to communicate to the central monitoring station (if
cellular communication path is selected).
Default: 0000000000
Valid range: 0000000000 to FFFFFFFFFF
CMS Cellular 2 DNIS
The DNIS is used in addition to the account code to identify
the communicator module at the central monitoring station.
- 27 -
3061 (0BF5)
0000 to 65535
Blank
32 characters ASCII
Blank
32 characters ASCII