DSC iotega WS901 Reference Manual page 15

1. Enable auto enroll using the installer portal.
2. Power up the wireless device and press the Enroll button until the on-board LED lights steady. The serial number is
displayed.
3. Confirm you want to enroll the device then configure the available options.
4. Submit the settings to finish enrollment.
5. Continue the above process until all devices are enrolled.
The wireless devices in the table below each have a dedicated Enroll button, located on the circuit board inside the plastic
casing. A Phillips screw must be removed on most devices to gain access. Refer to the installation instructions provided
with the device for more information.
PGx901 Indoor siren
PGx904 PIR/Pet Immune motion detector
PGx914 PIR/Pet Immune motion detector
PGx905 Temperature detector
PGx911 Outdoor siren
Carbon Monoxide detector
PGx913
Note: enrolls automatically on power-up
PGx912 Glassbreak detector
PGx916 Smoke and heat detector
Wireless repeater
PGx920
Note: hold Enroll button until red and green LEDs light steady
PGx922 Glassbreak detector
To enroll wireless keys:
PGx929/PGx939 4-button wireless key
PGx949 2-button wireless key
PGx938 Panic key
Section 3: Installation
Press and hold [*] button until LED lights steady then release.
Press and hold unlock button until LED lights steady then release.
Press and hold button until LED lights steady then release.
- 12 -
PGx924 Curtain motion detector
PGx926 Smoke detector
PGx935 Shock detector and magnetic contact
PGx944 Tower Cam motion detector
PGx945 Magnetic contact with Aux.
PGx974 Mirror PIR with anti-masking
PGx975 Magnetic contact (vanishing)
PGx984 Mirror PIR motion detector
PGx985 Flood detector
PGx994 Outdoor PIR motion detector