Page 1
Optimyst cassette. For ® your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7213750100R02...
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. W ARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
Welcome & Congratulations Thank you and congratulations for choosing to purchase an Optimyst ® cassette from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
FOR THESE MODELS dropped or damaged, or dropped (6909051242, 6909051243, into water. Contact Dimplex Techni- 6909051262,6909051263, cal Service at 1-888-346-7539 for 6909051261) IS 120VAC, 60 HZ, replacement parts.
To reduce the risk of electric 12VAC halogen bulbs type MR 16. shock, this appliance has a three Contact Dimplex Technical Service pronged plug. This plug will fit in a at 1-888-346-7539 for replacement grounded outlet only one way. If the bulbs.
Check with a may exceed the current rating of qualified electrician or serviceman the circuit breaker. Figure 1 Mantel Installation Install the fireplace into the mantel (refer to mantel assembly instructions). www.dimplex.com...
Page 7
Installation Figure 2 DFI400: 15.75 in. (400mm) DFI600: 22.05 in. (560mm) Installation Surface 6.7 in. (170mm) Air Inlet DFI400: 100cm DFI600: 150cm Exit for Cord Supports: 0.75 in. (19 mm) high New Construction Figure 3 1. Mark the desired location on 1.2 in.
1/8 tsp of salt (0.5 Remote mL) added to the water reservoir. Control (The addition of additional salt should only be used when you notice that the unit is not produc- ing mist as expected.) NOTE: During initial Housing installation, the Refill Container www.dimplex.com...
Page 9
Assembly Figure 5 Cover Emitter Retaining Housing Transducer Wire Slot Water Tank should be refilled after the Figure 6 Reservoir has filled to ensure the maximum operating time. Install the media on top, media tray and media (if applicable), so that the opening is not blocked (Figure 6).
30 seconds before the flames return. A. On/Off Switch Supplies power to the cassette. B. Mode Selector Switch Press once to turn on the flame effect. This will be indicated by an audible “beep”. Although the lights www.dimplex.com...
Page 11
Operation Remote Control Figure 8 The On/Off Switch must be in the ‘ON’ ( I ) position in order for the remote control to operate. (Figure Standby Button NOTE: To operate correctly, the remote control must be pointed Button towards the remote control sensor. To operate, push the ON but- ton to turn fireplace on, push the Standby button to turn the fire-...
® 12VAC halogen bulbs type MR 16. as the tap water is not considered Contact Dimplex Technical Service to be hard water. In the event your at 1-888-346-7539 for replacement tap water is hard, you may use bulbs.
Page 13
Maintenance Filter Cleaning in front of the fire and ob- serve which lamp needs to be The air filter can be removed and changed. gently rinsed with water to clean Turn the unit off, and unplug and dried on a towel before rein- the cassette.
What Dimplex will do in the event of a purchaser assumes the entire cost of all defect necessary servicing or repair.
Page 15
ANY THIRD PARTY, WHETHER IN CON- tive product or part without charge. If TRACT, IN TORT, OR ON ANY OTHER Dimplex is unable to repair or replace BASIS, FOR ANY INDIRECT, SPECIAL, such product or part, or if repair or...