Volvo V60 TWIN ENGINE 2018 Owner's Manual page 562

WHEELS AND TYRES
|| 5. Screw together the towing eye with the
wheel wrench until the stop position as per
the instructions.
IMPORTANT
The towing eye must be screwed into the
wheel bolt wrench* as far as possible.
6. Remove the plastic caps from the wheel
bolts with the intended tool.
7. With the car still on the ground, use the
wheel bolt wrench/towing eye to undo the
wheel bolts ½-1 turn by pressing downwards
(anticlockwise).
560
8. When raising the car, it is important that the
jack or lifting arms are fitted in the intended
points on the car's underbody. The triangle
markings in the plastic cover indicate the
locations of the jacking/lifting points. There
are two jacking points on each side of the
car. There is a recess for the jack at each
point.
9. Position the jack on level, firm and non-slip-
pery ground under the jacking point that will
be used.
10. Crank up until it is correctly aligned and so
that it makes contact with the car's jacking
point. Check that the head of the jack (or the
lift arms at a workshop) is correctly posi-
tioned in the jacking point so that the bump
in the centre of the head fits into the jacking
point hole and the base is positioned verti-
cally below the jacking point.
11. Turn the jack so that the crank is as far away
from the side of the car as possible, at which
point the jack's arms are perpendicular to the
direction of the car.
12. Raise the car high enough to allow the wheel
to be removed to move freely. Remove the
wheel bolts and lift off the wheel.
Related information
• Settings for level control* (p. 461)
When changing wheels (p. 557)
•
Raise the car (p. 598)
•
Jack* (p. 557)
•
Tool kit (p. 557)
•
Fitting the wheels (p. 561)
•
* Option/accessory.