Volvo V60 TWIN ENGINE 2018 Owner's Manual page 487

Hide thumbs Also See for V60 TWIN ENGINE 2018:
Table of Contents

Advertisement

three programmable buttons and one indicator
lamp in the mirror glass.
For more information about HomeLink
www.HomeLink.com or call
00 8000 466 354 65 (or the toll number
14
+49 6838 907 277)
.
Save the original remote controls for future pro-
gramming (e.g. when changing to another car or
for use in another vehicle). It is also recom-
mended that the programming for the buttons is
deleted when the car is sold.
Related information
®
Using HomeLink
* (p. 487)
®
Programming HomeLink
* (p. 485)
®
Type approval for HomeLink
12
Applies to certain markets.
13
HomeLink and the HomeLink house symbol are registered trademarks of Gentex Corporation.
14
Note that the toll-free number may not be available depending on operator.
Applies to certain markets.
15
Programming HomeLink
Follow these instructions to program
®
®
, visit
HomeLink
individual buttons.
NOTE
In certain vehicles the ignition must be
switched on or in "accessory position" before
HomeLink
possible, fit new batteries in the remote con-
trol that shall be replaced by HomeLink
faster programming and improved transmis-
sion of the radio signal. The HomeLink
tons should be reset before programming.
* (p. 488)
WARNING
While programming HomeLink
door or gate being programmed may activate.
For this reason, make sure that nobody is in
the vicinity of the door or gate while program-
ming is in progress. The car should be outside
the garage while a garage door opener is
being programmed.
®
15
*
, reset all programming or reprogram
®
can be programmed or used. If
®
for
®
but-
®
, the garage
STARTING AND DRIVING
1. Aim the remote control towards the
®
HomeLink
button to be programmed and
hold it approx. 2-8 cm (approx. 1-3 inches)
from the button. Do not obstruct the indicator
®
lamp on HomeLink
.
Note: The ability of some remote controls to
®
program HomeLink
is improved at a dis-
tance of approx. 15-20 cm (approx. 6-12
inches). Bear this in mind if problems occur
with the programming.
2. Press and hold depressed both the button
on the remote control and the button to be
reprogrammed on HomeLink
®
.
}}
485
* Option/accessory.

Advertisement

Table of Contents
loading

Table of Contents