Volvo V60 TWIN ENGINE 2018 Owner's Manual page 442

Hide thumbs Also See for V60 TWIN ENGINE 2018:
Table of Contents

Advertisement

STARTING AND DRIVING
Braking on gritted roads
When driving on salted roads, a layer of salt may
form on the brake discs and brake linings.
This may extend braking distance. You should
therefore maintain a greater safety distance to
vehicles in front. In addition, make sure you do
the following:
Brake now and again to remove any layer of
salt. Make sure that other road users are not
put at risk by the braking.
Gently depress the brake pedal after finish-
ing driving and before starting your next trip.
Related information
Foot brake (p. 438)
Braking on wet roads (p. 439)
440
Brake system maintenance
Check brake system components regularly for
wear.
To keep the car as safe and reliable as possible,
follow the Volvo service intervals as specified in
the Service and Warranty Booklet. New and
replaced brake linings and brake discs do not
provide optimal braking effect until they have
been "worn in" for a few hundred kilometres
(miles). Compensate for the reduced braking
effect by depressing the brake pedal harder.
Volvo recommends only fitting brake linings that
are approved for your Volvo.
IMPORTANT
The wear on the brake system's components
must be checked regularly.
Contact a workshop for information about the
procedure or engage a workshop to carry out
the inspection - an authorised Volvo work-
shop is recommended.
Related information
Foot brake (p. 438)
Parking brake
The parking brake prevents the car from rolling
away from stationary by means of mechanically
locking/blocking two wheels.
The control for the parking brake is located in the tunnel
console between the seats.
A faint electric motor noise can be heard when
the electrically-operated parking brake is being
applied. The noise can also be heard during the
automatic function checking of the parking brake.
If the car is stationary when the parking brake is
activated, it only acts on the rear wheels. If it is
activated when the car is moving then the normal
foot brake is used, i.e. the brake acts on all four
wheels. Brake function changes over to the rear
wheels when the car is almost stationary.

Advertisement

Table of Contents
loading

Table of Contents