14
ELECTRICAL SYSTEM
14.12
Checking the headlight setting
–
Remove the screw on the rear of the turn signal housing.
–
Remove turn signal glass
–
Press the bulb carefully into the socket, turn it counterclockwise by about 30°, and pull
it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new bulb carefully into the socket and turn it clockwise all the way.
B00981-10
Turn signal (RY10W / socket BAU15s) (
–
Position the turn signal glass.
–
Insert the screw and turn it counterclockwise first until it engages in the thread with a
light jerk. Tighten the screw slightly.
–
Check that the turn signal system is functioning properly.
–
Position the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
Guideline
Distance
–
Position the vehicle vertically at a distance
low beam.
Guideline
400726-10
Distance
–
The rider, with luggage and passenger if applicable, now mounts the motorcycle.
1
.
B
under the first mark.
B
A
p. 176)
5 cm (2 in)
A
in front of the wall and switch on the
5 m (16 ft)
135