Table of Contents
Advertisement
Problem/error
Cause
Laundry not dried
• Filters are not clean.
or drying takes too
long.
• Dryer is placed in a closed
• Laundry was not sufficiently
• Amount of laundry dried in
• Laundry (such as bedding)
Unevenly dried
• Laundry of varying types and
laundry.
A slight hitting
• If the dryer is out of use for
noise appears.
The door opens
• Excessive load on the door
during drying.
room; room that is too cold; or
room that is too small and the
air overheats as a result.
wrung or spun.
the appliance is too large or
insufficient.
gets tangled.
thickness, and excessive
amount of laundry.
a long period of time, the
same points of load-bearing
elements or components
are under stress for a long
time, causing temporary
deformation.
(too much laundry in the
drum).
Customer Care Center, 1-800-898-1879, www.askona.com
What to do?
• Clean the filters (see chapter "CLEANING AND
MAINTENANCE").
• Make sure there is adequate supply of fresh air
to the dryer; for example, open the door and/or
window.
• Check if the temperature in the room where the
dryer is installed is too high or too low.
• If the load is still wet after completed drying cycle,
an appropriate drying program should be run
again (after cleaning filters).
• Use a suitable program or extra functions.
• Close the buttons or zippers on the laundry before
drying. Select a suitable program (e.g. the bedding
program).
• After the drying process, loosen the laundry and
select an additional drying program (e.g. timed
drying program).
• Make sure you have sorted the laundry by type
and thickness, whether you have added a suitable
amount of laundry to the drum, and whether you
have selected a suitable program.
• The noise will subside without any intervention.
• Reduce the amount of laundry.
41
Advertisement
Table of Contents
