Asko T411HS W U Series Instructions For Use Manual page 27

STEP 7:
END OF PROGRAM
Cycle completed successfully
Anti
creasing Cycle completed successfully
Cycle completed successfully
Open the door towards you and remove the laundry from the dryer.
Make sure the dryer drum is empty, then close the door.
5 minutes after the end of the program or last activation, the display will switch off to standby mode in order to
save power.
The display will light up again if you press the ON/OFF button or open the dryer door.
After each drying cycle, clean the net fi lter in the door and empty the condensate tank. See chapter
"CLEANING AND MAINTENANCE".
A clogged net fi lter and heat pump fi lter may result in activation of the automatic overheating switch-off
device. Clean the fi lter, wait for the machine to cool down, and try running it again. If the dryer still fails to
start, call a service technician.
After the drying process, unplug the dryer power cord from the power outlet.
Clean door filter
Customer Care Center, 1-800-898-1879, www.askona.com
After the end of the drying program, the
Start
new
display will indicate that the program has
been successfully completed ("Cycle
completed successfully").
If you have selected the "Anti-crease"
option, the dryer will continue to operate
after the end of the drying cycle for the
amount of time specifi ed upon selection
of this program setting.
After the drying cycle, you have the
Start Add
new fav
possibility to save the program as
a favorite program (see "Favourite
programs").
5 6
Clean the net fi lter in the door
Ok
(see chapter "CLEANING AND
MAINTENANCE").
6
27