Suzuki DF115BG 2021 Owner's Manual page 24

Automatic trim angle adjusutment
This outboard motor is equipped with automatic
trim angle adjustment function. The function
automatically adjusts the trim angle appropri-
ately. Refer to Auto Trim in METER (OPTION)
MULTI-FUNCTION GAUGE section.
TRIM TAB ADJUSTMENT
This adjustment is used to compensate for the
possible tendency of your boat to veer slightly
to port or starboard. This tendency could be
due to such things as propeller torque, motor
mounting position, etc.
To adjust the trim tab:
1. Loosen the bolt A that holds the trim tab in
place.
2. If the boat tends to veer to port, move the
rear end of the trim tab toward the port side.
If the boat tends to veer to starboard, move
the starboard side.
3. Tighten the bolt that holds the trim tab in
place.
After adjusting the trim tab, check to see if the
boat still tends to veer to one side. If necessary,
readjust the trim tab.
CONTROL HANDLE ADJUSTMENT
The control handle friction and control handle
detent force can be adjusted to suit operator's
preference. The control handle friction adjust-
ment will change the overall effort to move the
control handle. This will help prevent undesired
movement of the control handle in rough water
conditions. Consult your authorized Suzuki
marine dealer to adjust the control handle fric-
tion and detent force.
Type A
Type B
Type
A Friction and detent force
B
IDLE SPEED ADJUSTMENT
The idle speed has been factory adjusted
between 650 – 750 r/min in neutral.
NOTE:
If idle speed cannot be set within the specified
range, contact your authorized Suzuki Marine
Dealer.
THROTTLE
SELECT
ONLY
Adjustable item
Friction
21