Husqvarna TC 85 2023 Owner's Manual page 70

11 SERVICE WORK ON THE CHASSIS
68
–
Check the chain sliding guard for wear.
» If the lower edge of the chain pins is in line with, or below,
the chain sliding guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
–
Tighten screws on the chain sliding guard.
Guideline
Remaining
screws, chassis
H02533-01
–
Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below
the chain sliding piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten screw on the chain sliding piece.
Guideline
Screw, chain slid-
ing piece
H02531-01
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
» If the light part of the chain guide is worn:
–
Change the chain guide.
400985-01
M6 10 Nm (7.4 lbf ft)
M8 15 Nm
(11.1 lbf ft)