Gravely Pro-Stance 36 CARB Owner's/Operator's Manual page 24

4. Turn engine oil filter counterclockwise to
remove.
5. Apply a film of clean engine oil to gasket
of new filter.
IMPORTANT: Avoid Damage! Do not use
wrench to tighten oil filter.
6. Install filter. Turn filter clockwise until
gasket makes contact with mounting
surface. Tighten 1/2 to 3/4 turn after
gasket contact.
7. Wipe off area around engine oil dipstick.
8. Add oil per engine manual
recommendations
9. Insert dipstick. Tighten cap.
10. Start engine and run at slow throttle for
approximately two minutes. Check for
leaks around filter and drain tube.
11. Stop engine.
12. Remove dipstick.
13. Insert dipstick and allow cap to rest on
threads of filler. Do not tighten cap.
14. Remove dipstick. Add oil as needed to
bring level to the full mark without
overfilling.
IMPORTANT: Avoid Damage! To prevent
extensive engine wear or damage, always
maintain the proper engine oil level. Never
operate the engine with the oil level below the
add mark or over the full mark.
1
3
1. Engine Oil Fill/Dipstick
2. Engine Oil Drain Pipe
3. Engine Oil Filter
4. Hydraulic Fluid Cold Fill Indicator Mark
EN - 24
4
2
Figure 11