Table of Contents
Advertisement
CHANGING THE PRESSER FOOT
CAUTION
• Always touch
keys and buttons before changing the presser
foot. If
is not touched and the "Start/
Stop" button or another button is pressed, the
machine will start and may cause injury.
• Always use the correct presser foot for the
selected stitch pattern. If the wrong presser
foot is used, the needle may strike the presser
foot and break, and may cause injury.
• Make sure that the presser foot is installed in
the correct direction, otherwise the needle
may strike the presser foot, breaking the
needle and causing injuries.
IMPORTANT
• Use presser feet made for this machine.
Replacing the Presser Foot
a
Press
(Needle position button) to raise the needle.
b
Touch
to lock all keys and buttons.
*
If the message [OK to automatically lower the
presser foot?] appears on the LCD screen, touch
to continue.
c
Raise the presser foot lever.
d
Press the black button on the presser foot holder and
remove the presser foot.
a
e
Place the new presser foot under the holder, aligning
the foot pin with the notch in the holder. Lower the
presser foot lever so that the presser foot pin snaps into
the notch in the holder.
a
on the screen to lock all
1 Black button
2 Presser foot holder
1 Notch
2 Pin
CHANGING THE PRESSER FOOT
f
Raise the presser foot lever to check that the presser
foot is securely attached.
g
Touch
to unlock all keys and buttons.
Attaching the Presser Foot with the Included
Adapter
Some presser feet require using the included adapter and
small screw, for example, the free motion echo quilting foot
"E" and so on.
Attaching the Included Adapter and Small
Screw
a
Follow the steps in "Replacing the Presser Foot" on
page 45.
b
Loosen the screw of the presser foot holder to remove
the presser foot holder.
b
c
Remove the screw of the presser foot completely from
the presser foot shaft.
1 Presser foot holder
screw
2 Presser foot holder
1
45
Advertisement
Table of Contents
