Table of Contents
Advertisement
EMBROIDERING A PATTERN
CAUTION
• When embroidering on large items (especially
jackets or quilts), do not let the fabric hang off
of the table. Otherwise, the embroidery unit
cannot move freely and the embroidery frame
may strike the needle, causing the needle to
break and possibly causing injury.
Embroidery Needle Plate Cover
Under some conditions, based on the type of fabric,
stabilizer, or thread being used, there may be some
looping in the upper thread. In this case, attach the
included embroidery needle plate cover to the needle
plate. Attach the cover by inserting the two projections on
the underside of the cover into the notches on the needle
plate as shown below.
a
To remove the embroidery needle plate cover, place your
fingernail in the groove and lift the plate out.
CAUTION
• Push the embroidery needle plate cover as far
as possible to attach it. If the embroidery
needle plate cover is not securely attached, it
may cause the needle to break and cause
injury.
138
1 Groove
2 Projection
3 Notch
c
Embroidering Patterns
a
Prepare embroidery threads of the colors shown on the
screen.
2
1 Embroidery color order
2 Cursor
Memo
• The [+] cursor moves over the pattern, showing
which part of the pattern is being embroidered.
b
Using the automatic needle threader, thread the
machine for the first color. (page 36)
c
Lower the presser foot, then press the "Start/Stop"
button to start embroidering.
When the first color is completely embroidered, the
machine will automatically trim the threads and stop.
The embroidery foot will then automatically be
raised.
On the embroidery color order display, the next
color will move to the top.
1
Advertisement
Table of Contents
