Table of Contents
Advertisement
4
Chapter
BEFORE EMBROIDERING
Embroidery Step by Step
Follow the steps below to prepare the machine for
embroidery.
Step 1, 2
Step 3
Step 7
Step 5
Step #
Aim
1
Presser foot
Attach embroidery foot "W+"
attachment
with LED pointer.
2
Checking the
Use needle 75/11 for
needle
embroidery.
3
Embroidery unit
Attach the embroidery unit.
attachment
4
Bobbin thread
For the bobbin thread, wind
setup
embroidery bobbin thread and
set it in place.
5
Fabric preparation Attach a stabilizer material to
the fabric, and hoop it in the
embroidery frame.
6
Pattern selection
Turn the main power to ON,
and select an embroidery
pattern.
7
Embroidery frame
Attach the embroidery frame
attachment
to the embroidery unit.
8
Checking the
Check and adjust the size and
layout
position of the embroidery.
9
Embroidery upper
Set up embroidery upper
thread setup
thread according to the
pattern.
BASIC EMBROIDERY
Step 9
Step 6, 8
Step 4
Action
Page
103
42
104
30
126
105
129
130
36
Attaching Embroidery Foot "W+" with LED
Pointer
CAUTION
• When attaching an embroidery foot, always
touch
on the screen. You may
accidentally press the "Start/Stop" button and
possibly cause injury.
• Be sure to use the embroidery foot "W+" with
LED pointer when doing embroidery. Using
another embroidery foot may cause the needle
to strike the embroidery foot, causing the
needle to break and possibly causing injury.
a
Remove the presser foot and presser foot holder.
(page 45)
b
Position the embroidery foot "W+" with LED pointer
on the presser foot bar by aligning the notch of the
presser foot to the large screw.
Side view
c
Hold the embroidery foot in place with your right
hand, and then use the disc-shaped screwdriver to
securely tighten the presser foot holder screw.
a
1 Presser foot holder screw
CAUTION
• Use the disc-shaped screwdriver to firmly
tighten the presser foot holder screw. If the
screw is loose, the needle may strike the
embroidery foot and break, possibly cause
injury.
BEFORE EMBROIDERING
4
103
Advertisement
Table of Contents
