Icom IC-V82 Instruction Manual page 41

NOTE: Scan edges, 1A–3A/1b–3b, must be programmed
in advance. Program them in the same manner as regular
memory channels. (p. 21)
If the same frequencies are programmed into the scan
edges, programmed scan will not proceed.
A
FUNC
1
TONE
4
DUP
7
PRIO
MONI PWR
B C D
CALL MR CLR
2 3
P.BEEP T.SCAN BANK
5 6 0
SCAN SKIP OPT
8 9
SET H/M/L ENT
■ Memory scan
Memory scan repeatedly scans all programmed memory
channels, except those set as skip channels.
q Push [C•
] to select memory mode, if necessary.
MR
• " X " appears.
w Push [A•
] and [5•
FUNC SCAN
• To change the scan direction, push [Y Y ] or [Z Z ].
• When [VOL] is assigned as tuning dial, rotate [VOL] to change
the scan direction. (pgs. 14, 63)
5
A
Push
FUNC
SCAN
e Push [D•
] to stop the scan.
CLR
• Bank scan —Select the desired bank at above step q.
q Push [A•
] and [#•
FUNC BANK
dition.
w Rotate [VOL] to select the desired bank, A to J.
e Push [✱•
] (or [D•
ENT CLR
SCAN OPERATION
] to start the scan.
] to select memory bank con-
]) to set the bank.
8
8
29