Philips 8601 Series User Manual page 82

can take a few minutes.
6 - Press  (left) to go back one step or press 
BACK to close the menu.
Factory Settings
You can set the TV back to the original TV settings
(the factory settings) for picture, sound and Ambilight.
To switch back to the original settings...
1 - Press  SETTINGS, select All Settings and
press OK.
2 - Select General Settings, select Factory
Settings and press OK.
3 - Press  (left) to go back one step or press 
BACK to close the menu.
Channel List Copy
Introduction
Channel List Copy is intended for dealers and expert
users. In some countries, Channel List Copy is only
available for copying satellite channels.
With Channel List Copy, you can copy the channels
installed on one TV onto another Philips TV of the
same range. With Channel List Copy, you avoid the
time-consuming channel search by uploading a
predefined channel list on a TV. Use a USB flash drive
of minimum 1 GB.
Conditions
• Both TVs are from the same year range.
• Both TVs have the same hardware type. Check the
hardware type on the TV type plate on the back of
the TV. Typically noted as Q . . . LA
• Both TVs have compatible software versions.
Current channel version
To check the current version of the channel list...
1 - Press  SETTINGS, select All Settings and
press OK.
2 - Select Channels, select Channel List Copy,
select Current Version and press OK.
3 - Press OK to close.
Current software version
To check the current version of the TV software...
1 - Press  SETTINGS, select All Settings and
press OK.
2 - Select Update Software, select Current
Software Info and press OK.
3 - The version, release notes and creation date are
shown. Also, the Netflix ESN Number is shown if
available.
4 - Press  (left) to go back one step or press 
BACK to close the menu.
Copy a Channel List
To copy a channel list...
1 - Switch on the TV. This TV should have channels
installed.
2 - Plug in a USB flash drive.
3 - Press  SETTINGS, select All Settings and
press OK.
4 - Select Channels, select Channel List Copy,
select Copy to USB and press OK. Enter your PIN
code if necessary.
5 - When copying is done, unplug the USB flash
drive.
6 - Press  (left) to go back one step or press 
BACK to close the menu.
Now you can upload the copied channel list onto
another Philips TV.
Upload a Channel List
To not Installed TVs
Depending on whether your TV is already installed or
not, you must use a different method to upload a
channel list.
To a TV that is not yet installed
1 - Plug in the power plug to start the installation and
select language and country. You can skip the
channel search. Finish the installation.
2 - Plug in the USB flash drive that holds the channel
list of the other TV.
3 - To start the channel list upload,
press  SETTINGS, select All Settings and
press OK.
4 - Select Channels, select Channel List Copy,
select Copy to TV and press OK. Enter your PIN
code if necessary.
5 - The TV notifies you if the channel list is copied to
the TV successfully. Unplug the USB flash drive.
To Installed TVs
Depending on whether your TV is already installed or
not, you must use a different method to upload a
channel list.
To an already installed TV
1 - Verify the country setting of the TV. (To verify this
setting, see chapter Reinstall All Channels. Start this
procedure until you reach the country setting. Press
 BACK to cancel the installation.)
If the country is correct continue with step 2.
If the country is not correct, you need to start a
reinstallation. See chapter Reinstall All Channels and
start the installation. Select the correct country and
skip the channels search. Finish the installation. When
done, continue with step 2.
82