Philips 8601 Series User Manual page 10

6 - Select Connect to make the connection.
7 - A message will be shown when the connection is
successful.
Problems
In Help, press the colour key
up Troubleshooting for more information.
Wired Connection
What You Need
To connect the TV to the Internet, you need a
network router with a connection to the
Internet. Use a high-speed (broadband) connection
to the Internet.
Make the Connection
To make a wired connection...
1 - Connect the router to the TV with a network cable
(Ethernet cable**).
2 - Make sure that the router is switched on.
3 - Press  SETTINGS, select All Settings and press
OK.
4 - Select Wireless and Networks and
press  (right).
5 - Select Wired or Wi-Fi > Connect to
Network and press OK.
6 - Select Wired and press OK. The TV constantly
searches for the network connection.
7 - A message will be shown when the connection is
successful.
If the connection fails, you can check the DHCP
setting of the router. DHCP should be switched on.
**To fulfill EMC regulations, use a shielded FTP Cat.
5E Ethernet cable.

Keywords and look
Network Settings
View Network Settings
You can view all current network settings here. The IP
and MAC address, signal strength, speed, encryption
method, etc.
To view the current network settings...
1 - Connect the router to the TV with a network cable
(Ethernet cable**).
2 - Make sure that the router is switched on.
3 - Press  SETTINGS, select All Settings and press
OK.
4 - Select Wireless and Networks and
press  (right).
5 - Select Wired or Wi-Fi > View Network Settings
and press OK.
6 - Press  (left) to go back one step or press 
BACK to close the menu.
Network Configuration
If you are an advanced user and want to install your
network with Static IP addressing, set the TV to Static
IP.
To set the TV to Static IP...
1 - Press  SETTINGS, select All Settings and press
OK.
2 - Select Wireless and Networks and
press  (right).
3 - Select Wired or Wi-Fi > Static IP Configuration
and press OK.
4 - Configure the connection.
5 - Press  (left) to go back one step or press 
BACK to close the menu.
Switch On with Wi-Fi (WoWLAN)
You can switch this TV on from your smartphone or
tablet if the TV is in Standby. The setting Switch On
with Wi-Fi (WoWLAN) must be switched on.
To switch on WoWLAN...
1 - Press  SETTINGS, select All Settings and press
OK.
2 - Select Wireless and Networks and
press  (right).
3 - Select Wired or Wi-Fi > Switch on with Wi-Fi
(WoWLAN) and press OK.
4 - Select On and press OK.
5 - Press  (left) to go back one step or press 
BACK to close the menu.
10