WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
Remove the
base
cover.
Procedure
1
Disconnect the battery cable from the system board (applicable only if not disconnected earlier).
2
Remove the four screws (M2x3) that secure the battery to the palm-rest assembly.
3
Lift the battery off the palm-rest assembly.
4
Turn the computer over, open the display, then press and hold the power button for five seconds to ground the system board.
computer. After working inside your computer, follow the instructions in
Removing the battery
www.dell.com/
Removing the battery
8
After working inside
19