Mounting - Samson 43-2 Mounting And Operating Instructions

1
Fig. 5-2: Installation example

5.3 Mounting

The components (valve, control thermostat
and, if applicable, thermowell) of the regula-
tor are delivered separately. The activities
listed below are necessary for installation
and before start-up of the regulator.
NOTICE
!
Risk of regulator damage due to exces-
sively high or low tightening torques.
Observe the specified torques when tighten-
ing regulator components. Excessive tighten-
ing torques lead to parts wearing out more
quickly. Parts that are too loose may cause
leakage.
Î Observe the specified tightening torques
(see 'Tightening torques' in Annex).
EB 2171 EN
2 3 6 4 5
NOTICE
!
Risk of regulator damage due to the use of
unsuitable tools.
Î Only use tools approved by SAMSON
(see 'Tools' in Annex).
NOTICE
!
Risk of regulator damage due to the use of
unsuitable lubricants.
Î Only use lubricants approved by
SAMSON (see 'Lubricants' in Annex).
Installation
1 Shut-off valve
2 Strainer
3 Temperature regulator
4 Thermometer
5 Temperature sensor
6 Shut-off valve
5-5