Samson 43-1 Mounting And Operating Instructions
Temperature regulators
Hide thumbs
Also See for 43-1:
- Mounting and operating instructions (44 pages) ,
- Mounting and operating instructions (68 pages)
Related Manuals for Samson 43-1
Summary of Contents for Samson 43-1
- Page 1 Temperature Regulators Series 43 Type 43-1 Type 43-2 ⋅ ⋅ ⋅ Fig. 1 ⋅ Temperature regulator versions Mounting and operating instructions EB 2171 EN Edition August 2003...
-
Page 2: Table Of Contents
Troubleshooting Dimensions in mm and weights Customer inquiries Typetesting The Type 43-1 and Type 43-2 Temperature Regulators are typetested accord - ing to DIN 3440 by the German technical surveillance association TÜV. Register number available on request EB 2171 EN... - Page 3 Allow the plant to fill up slowly on start-up. Make sure regulators are frost protected when used to control freezing media. If the sensor is used in combination with a thermowell, only SAMSON thermo - wells should be used. EB 2171 EN...
-
Page 4: Design And Principle Of Operation 4
Design and principle of operation Principle of operation: 1. Design and principle of operation 1.1 Temperature regulator 1.2 Version with safety thermostat Note: Thermostats that function according to the 1.3 Version with double adapter vapor pressure principle are described in and/or manual adjustment EB 2430-3 EN. - Page 5 Design and principle of operation Type 43-1 Type 43-2 (20 Nm) Fig. 2 ⋅ Sectional drawing EB 2171 EN...
-
Page 6: Installation
Installation 2. Installation 2.1.2 Additional installation instruc- tions 2.1 Installing the valve 2.2 Installing the temperature sen- 2.1.1 Strainer Note: To prevent damage caused by corro- sion, make sure that the same kinds of ma - terials are used when installing the sensor or thermowell. -
Page 7: Operation
Operation 2.2.1 Capillary tube 3. Operation 3.1 Set point adjustment ˚C ˚C 70...150 70...150 50...120 50...120 40...100 40...100 25...70 25...70 0...35 0...35 Fig. 4 ⋅ Adjustment diagrams EB 2171 EN... -
Page 8: Maintenance – Replacing Parts
Maintenance - Replacing parts 4. Maintenance - Replacing parts Note: To replace the seat, a special tool is additionally required. Refer to the EB 029 EN (formerly WA 029 EN) for the product numbers 2710 to 2730 (also avail- able on the Internet at http://www.sam- son.de/pdf_en/e00290en.pdf). -
Page 9: Troubleshooting
Troubleshooting 5. Troubleshooting Problem Possible source Remedy EB 2171 EN... -
Page 10: Dimensions In Mm And Weights
Dimensions in mm and weights 6. Dimensions in mm and weights Type 43-1 Type 43-2 EB 2171 EN... -
Page 11: Customer Inquiries
Dimensions in mm and weights Type 43-2 Type 43-2 G½ (G¾) Ø12(19) Ø9.5(16) Type 43-1 Type 43-2 7. Customer inquiries EB 2171 EN... - Page 12 ⋅ ⋅ ⋅ ⋅ EB 2171 EN...