Samson 43 Series Mounting And Operating Instructions
Temperature regulator
Hide thumbs
Also See for 43 Series:
- Translation of original instructions (56 pages) ,
- Mounting and operating instructions (20 pages) ,
- Mounting and operating instructions (12 pages)
Related Manuals for Samson 43 Series
Summary of Contents for Samson 43 Series
- Page 1 Temperature Regulator Series 43 Type 43-2 N Fig. 1 ⋅ Type 43-2 N Mounting and operating instructions EB 2186 EN Edition July 2001...
- Page 2 Design and principle of operation 1. Design and principle of operation tional thermostat, or with a manual adjuster. For further details, refer to EB 2176 EN. 1.1 Temperature regulator Principle of operation: The temperature regulator works according The temperature regulator consists of the to the adsorption principle.
- Page 3 Design and principle of operation lower temperature range sensed by the sen- sor. Note: For thermostats working according to the vapor pressure principle, refer to EB 2430-3 EN. (20Nm) Valve body 1.1 Coupling nut with gasket and accessory weld-on fittings (must be ordered separately) Seat Plug...
-
Page 4: Installing The Valve
2.1.1 Strainer be controlled. A strainer (SAMSON Type 1 NI) must be in- 2.2 Installing the temperature sensor stalled upstream of the relevant valve, since sealing particles, globules or other im-... -
Page 5: Capillary Tube
Adjusting the set point cation where overheating and considerable 3. Operation idling times do not occur. A welding socket with a G 1/2 female 3.1 Adjusting the set point thread connection should be welded where the sensor is to be installed. To adjust the set point value, use the black plastic ring (set point adjuster 8) while watch- Seal the screw gland or thermowell into... -
Page 6: Troubleshooting
Adjusting the set point 4. Troubleshooting 5. Customer inquiries Should the temperature exceed the set point Should you have any inquiries regarding adjusted, the cause could be either contami- the temperature regulator, please submit the nation of seat and plug or wear and tear of following details: the seat and plug no longer ensuring tight (see also nameplate) - Page 7 Dimensions in mm 6. Dimensions in mm Bulb sensor with thermowell or with screw gland G½ Ø12 Ø9.5 Soldered ends 107 for ∅di =15, 103 for ∅di =18 Version with threaded ends SW30 SW30 Version with weld-on fittings SW30 EB 2186 EN...
- Page 8 SAMSON AG ⋅ MESS- UND REGELTECHNIK Weismüllerstraße 3 ⋅ D-60314 Frankfurt am Main Telefon (0 69) 4 00 90 ⋅ Telefax (0 69) 4 00 95 07 EB 2186 EN Internet: http://www.samson.de...