Table of Contents
Advertisement
Safety Instructions
To maintain the probe in a correct and safe condition, observe generally accepted safety
procedures in addition to the precautions specified in this section. The overall safety of any
system incorporating this product is the responsibility of the assembler of the system.
Symbols
These symbols appear on the probe and accessories or in this manual to alert you to important
safety considerations.
CAUTION of damage to probe or instrument, or WARNING of hazard to health.
Attend to the accompanying information to protect against personal injury or
damage. Do not proceed until conditions are fully understood and met.
ESD CAUTION Risk of Electrostatic Discharge (ESD) that can damage the probe
or instrument if anti-static measures are not taken.
DOUBLE INSULATION
Precautions
Connect and disconnect properly. Always connect the probe input lead to the probe accessories
before connecting to a voltage source. Ensure the connections are secure before applying voltage.
Do not disconnect leads or accessories from a live circuit.
Use only within the operational environment listed Do not use in wet or explosive atmospheres.
Use indoors ony.
Keep product surfaces clean and dry.
Be careful with sharp tips. The tips may cause bodily injury if not handled properly.
Do not operate with suspected failures. Before each use, inspect the probe and accessories for
any damage such as tears or other defects in the probe body, cable jacket, accessories, etc. If any
part is damaged, cease operation immediately and sequester the probe from inadvertent use.
Operating Environment
The accessory is intended for indoor use and should be operated in a clean, dry environment.
Before using this product, ensure that its operating environment is maintained within these
parameters:
Temperature 0° C - 50° C
Humidity: ≤85% Relative Humidity
Altitude: Up to to 3000m
Page 1
Advertisement
Table of Contents
