Table of Contents
Advertisement
1) Measurement input cable
The T3LVD20-200 measurement input cables connecting to the DUT. The connection between the
T3LVD20-200 input cables and the DUT will usually be made using grippers or alligator clip
connectors (supplied).
2) Offset adjustment
This button allows the user to remove any common mode offset up to + 60V.
3) Probe head to control box connection cable
This is a fixed connection cable between the probe head and the control box, of approximately 70
cm in length.
4) Power supply connection point
The external power supply is connected via a standard USB type B port which can be powered
from the supplied external USB wall plug adaptor or from an oscilloscope USB port.
5) Overload alarm indicator
When the amplitude of the acquired waveform surpasses the probe voltage range limit the overload
indicator will light and a buzzer will sound. Immediately reduce the amplitude of the input waveform.
6) BNC output connector
The probe control box BNC output connector can be connected to an oscilloscope via a standard
BNC cable. The oscilloscope input impedance should be set to 50 Ohms. Use a 50 Ohm
feedthrough adaptor for oscilloscopes that only have a 1 MOhm input impedance.
Included Accessories
Alligator Clips
Gripper Clips
50 Ohm Feedthrough Termination
BNC Output Cable
Test Hook
Page 3
Advertisement
Table of Contents
