HP ZBOOK STUDIO 16 G10 Maintenance And Service Manual page 55

3. Remove the battery (see
If you are replacing a memory module, remove the existing memory module:
1. Release the tape (1) that secures the memory module shield to the heat sink.
2. Lift and remove the memory module shield (2) from the system board.
The memory module shield is included in the Shield Kit, spare part number N10942-001.
When installing the memory module shield, be sure that the edges of the shield fit into all the clips
that are built into the system board.
3. Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then
remove the module (2). Use the same procedure to remove all memory modules.
To install a memory module, reverse the removal procedure.
NOTE: Memory modules are designed with a notch to prevent incorrect insertion.
48 Chapter 5 Removal and replacement procedures for authorized service provider parts
Battery on page 46).