Page 1
Hinge lever K31: Simulated hinge lever K21: Hinge roller lever List of Models Actuator Model Solder Molded lead wire Pin plunger D2JW-011 D2JW-011-MD Short hinge lever D2JW-01K1A1 D2JW-01K1A1-MD Hinge lever D2JW-01K11 D2JW-01K11-MD Simulated hinge lever D2JW-01K31 D2JW-01K31-MD Hinge roller lever...
Approx. 7 g (molded lead wire models, pin plunger models) Note: 1. The operating speed value shown is for pin plunger models. (For different models, contact your OMRON representative.) 2. The dielectric strength values shown apply for use with Separator (terminal type).
Page 3
Dimensions and Operating Characteristics Pin Plunger OF max. 2.45 N {250 gf} 1.6 dia. D2JW-011 RF min. 0.98 N {100 gf} PT max. 0.6 mm OT min.
Page 4
D2JW D2JW Simulated Hinge Lever OF max. 0.95 N {97 gf} D2JW-01K31 RF min. 0.19 N {20 gf} 0.3 t stainless-steel PT max. 5.5 mm spring lever OT min. 1.1 mm MD max. 0.6 mm 10.3 0.8 mm +0.05 2.35 dia.
D2JW D2JW Separator (Order Separately) Model Separator for D2JW Two, 2.4 0.1 dia. t=0.18 Precautions Cautions Leave the test piece in water for 30 min with the top of the test piece submerged 15 cm or more below the water level and the bottom of Mounting Dimensions the test piece submerged 1 m or more below the water level.
This manual is also suitable for:
D2jw-01k1a1D2jw-01k11D2jw-01k31D2jw-01k21D2jw-011-mdD2jw-01k1a1-md...
Show all