IBM 2073-700 Quick Installation Manual page 65

Table 16. NIS configuration information (continued)
Field Value
Use Id Map
[ ] Use ID Map - NIS is used to map
UNIX IDs to Windows IDs for an
environment where Active Directory
(AD) or Samba Primary Domain
Controller (PDC) is used for
Authentication.
ID MAP USER
RANGE
ID MAP GROUP
RANGE
1.
2. Log in with the admin password admin.
Easy Setup Wizard:
Note: For each window, complete the required information, then select Next,
verify that there is a green check mark when the task results are presented, and
select Close. If there is an error select the Details drop-down arrow and determine
the issue.
1. Accept the license agreement.
2.
Go to a personal computer that has an Ethernet connection to the file module
management IP address (refer to Table 8 on page 41), and point a supported
browser to that address. Use https prefix (for example, https://9.11.136.208 ).
You must use a supported browser. You can verify that you are using a
supported browser by going to the Support home website at
www.ibm.com/storage/support/storwize/v7000 and doing the following steps:
a. From the Search support input field, type browser. You are shown a search
result for IBM Storwize V7000 Supported Hardware List, Device Driver,
Firmware and Recommended Software Levels. Click the search entry.
b. Scroll down to the Other Hardware and Software section.
c. Find and select Management GUI.
Complete the system attributes as required. Refer to Table 10 on page 46. Select
Next.
Note
If the NIS Mode is Basic, leave this field blank.
If you checked NIS - NFS NetGroup support
without User ID Mapping in the Options field
of Table 13 on page 50, leave this field blank.
If you checked NIS - NFS NetGroup support
with User ID Mapping in the Options field of
Table 13 on page 50, then check the Use ID Map
field.
If the Use ID Map field is blank, leave this field
blank.
If the Use ID Map field is checked AND at least
one User Map rule is AUTO then you must
specify a User Range and/or a Group Range.
Example: 10000-20000.
Note: The User Range values must be a
minimum of 1024.
If the Use ID Map field is blank, leave this field
blank.
If the Use ID Map field is checked AND at least
one User Map rule is AUTO then you must
specify a User Range and/or a Group Range.
Example: 30000-40000.
Note: The Group Range values must be a
minimum of 1024.
Chapter 3. Configuring the system
55