Creating Pppoe Ipv6 Or Pppoe Dual Stack Wan Connection - D-Link DIR-806A User Manual

DIR-806A AC750 Wi-Fi Router
User Manual

Creating PPPoE IPv6 or PPPoE Dual Stack WAN Connection

On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 74. The page for creating a new PPPoE IPv6 connection. The General Settings section.
Parameter
Interface
Connection name
Enable connection
NAT
General Settings
A physical or virtual WAN interface to which the new connection
will be assigned.
A name for the connection for easier identification.
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
For the PPPoE Dual Stack type only.
If the switch is moved to the right, the network address translation
function is enabled. Do not disable the function unless your ISP
requires this.
Page 88 of 197
Configuring via Web-based Interface
Description