Troubleshooting - Jonsered FR 2216 MA Operator's Manual

Note: For safe disposal of used engine oil, see
on page 28 .
To do a check of the transmission oil
level
1. Remove the two screws, one on each side, and lift
off the transmission cover.
2. Make sure that the oil level in the transmission oil
tank is between the two horizontal lines on the tank.
Troubleshooting schedule
If you cannot find a solution to your problems in this
owner's manual, speak to your Jonsered service agent.
375 - 002 - 28.11.2017
3. Fill with engine oil if the oil level is below the lower
Disposal
line, but do not fill above the top line. See
data on page 29 for recommended oil.
To lubricate the belt adjuster
The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
1. Remove the 2 screws that hold the belt shield and lift
it off.
2. Lubricate with a grease gun, 1 nipple from the right
side below the lower belt pulley, until grease is
forced out.
3. Attach the belt shield and tighten the 2 screws.

Troubleshooting

Technical
25