Table of Contents
Advertisement
Setup menu list
SCENE FILE screen
Item
LOAD/SAVE/INIT Loads, saves and initializes settings of the scene file
assigned to the current scene dial position (one F1 – F6
scene file).
LOAD:
Loads data stored in camera-recorder memory.
SAVE:
Saves current values in camera-recorder memory.
INITIAL:
Returns settings to their factory defaults.
VFR
Enables or disables variable frame rate (VFR) mode at
1080i or 720P.
ON:
VFR operation
OFF:
VFR off
FRAME RATE
Adjusts the frame rate and exposure time at 1080i or
720P when VFR is on.
• 1080-59.94i:
1, 2, 4, 6, 9, 12, 15, 18, 20, 21, 22, 24, 25, 26, 27, 28,
30 FRAME
• 1080-50i:
1, 2, 4, 6, 9, 12, 15, 18, 20, 21, 22, 23, 24, 25 FRAME
• 720-59.94P:
1, 2, 4, 6, 9, 12, 15, 18, 20, 21, 22, 24, 25, 26, 27, 28, 30,
32, 34, 36, 40, 44, 48, 54, 60 FRAME
• 720-50P:
1, 2, 4, 6, 9, 12, 15, 18, 20, 21, 22, 23, 24, 25, 26, 27, 28,
30, 32, 34, 37, 42, 45, 48, 50 FRAME
SYNC SCAN
Selects synchro scan shutter display.
TYPE
sec:
Displays the shutter speed in fractions.
deg:
Displays the approximate shutter opening angle.
(SYNCHRO
Displays synchro scan shutter speeds to enable the
SCAN)
operator to synchronize the camera-recorder to computer
monitors.
• This function only displays the shutter speeds. Use the
SHTR/F.RATE dial to set a shutter speed.
• Set values (displayed values) are assigned to the
current scene file and manipulated using the LOAD,
SAVE and INIT functions.
"Setting SYNCHRO SCAN mode" (Page 50)
1/50.0
DETAIL LEVEL
Adjusts the level of image outline correction (in horizontal
and vertical directions).
– 7 ...0
V DETAIL LEVEL Adjusts the level of correction in vertical direction.
– 7 ...0
DETAIL CORING
Adjusts the level of noise reduction of the detail signal.
– 7 ...0
• Adjust towards – for a clearer image. Noise increases
slightly.
• Adjust towards + for less noise.
*1: The factory default when the SCENE FILE dial is set to F1.
___indicates the factory setting.
Setting
*1
... +7
*1
... +7
*1
... +7
*1
Notes
• A change in scene files affects
only the scene file at the
current scene dial position.
• Not available when compiling
to a clip in one-clip recording
mode.
• Not displayed when system
mode is 480i/576i.
• Cannot be set when 1080i is
selected with DVCPRO HD
recording and CAMERA MODE
is not set to 60i, 50i.
• Can only be set when VFR is
ON.
• A change to 24 fps may
cause the screen to flicker
momentarily.
• Brightness may change when
settings are switched.
• Displayed in blue when not
set to synchro scan mode and
when the SHTR/F.RATE dial
settings are not available.
129
Advertisement
Table of Contents
