Table of Contents
Advertisement
3
Initial Configuration
Using the Setup Wizard
There are only a few basic steps you need to set up the access point and provide a
connection for your Wi-Fi phone and network access for other wireless stations.
The Setup Wizard takes you through configuration procedures for the general
network settings, such as IP configuration, wireless network name (Service Set
Identifier), and wireless security. Follow these steps:
Launch the Setup Wizard – Click "Start with Setup Wizard" on the home page.
1.
Network Setting – Sets the access point's IP address assignment method and
2.
configures the local Dynamic Host Configuration Prototcol (DHCP) server and
Network Address Translation (NAT) settings.
There are three basic methods for configuring the access point's IP address:
• Dynamic IP — The IP address is assigned automatically from a home
gateway router or other device that has a DHCP server feature.
• PPPoE — The IP address is assigned automatically from an Internet service
provider (ISP) through an ADSL modem using Point-to-Point Protocol over
Ethernet (PPPoE). If your ISP has provided you with a user name and
password, enter these in the corresponding text boxes under PPPoE Setting.
• Static IP — The IP address is assigned manually by the user. This may be
required if your access point is connected to a home gateway router or other
device that does not support a DHCP server.
3-6
Figure 3-4. Setup Wizard - Network Setting
Advertisement
Table of Contents
