Table of Contents
Advertisement
1. Foam panel
2. Mounting plates
4.
Install the foam panels onto the assembly
(Figure
7).
10
Installing the Seat Belts
Parts needed for this procedure:
2
Seat-belt anchor
4
Bolts (3/8 x 3/4 inch)
4
Nuts (3/8 inch)
2
Seat-belt receiver end
4
Bolt (7/16 inch)
4
Nut (7/16 inch)
2
Seat-belt bracket
2
Seat belt
2
Bolt (3/8 x 7/8 inch)
Procedure
1.
Mount a seat-belt bracket to each ROPS tab
with 2 bolts (3/8 inch) as shown in
Figure 7
3. Bolts (1/4 inch)
4. Double-stick tape
Figure
1. Bolt (7/16 inch)
2. Bolt (3/8 x 7/8 inch)
2.
Torque the 4 bolts (3/8 inch) to 37 to 45 N∙m (27
to 33 ft-lb).
3.
Mount the retractable end of each seat-belt
g026279
assembly to each seat-belt anchor bracket with
a bolt (7/16 inch) and a nut (7/16 inch) as shown
in
Figure
Note:
a ROPS assembly, the seat-belt anchors are
already installed; proceed to
Harness (page
4.
Torque the 2 bolts (7/16 inch) to 67 to 83 N∙m
(49 to 61 ft-lb).
5.
Secure the left and right seat-belt anchor to the
front frame with 4 bolts (3/8 x 3/4 inch) and 4
nuts (3/8 inch) as shown in
8.
6.
Torque the 4 bolts (3/8 x 3/4 inch) to 37 to 45
N∙m (27 to 33 ft-lb).
9
Figure 8
3. Nut (7/16 inch)
8.
If your machine came equipped with
11 Routing the Wire
10).
Figure
Figure 9
g026673
9.
g026308
Advertisement
Table of Contents
