Toro 07320 Installation Instructions Manual page 5

2
Removing the Strut Assembly (for 2016 and Newer
Machines Only)
No Parts Required
Procedure
1. Raise the front of the machine off the ground and support it with jack stands.
2. Remove the front wheel.
3. Remove the hex-head bolt (3/8 x 4-3/4 inches) and flange nut (3/8 inch) from the spindle
4. Remove the hex-head bolt (3/8 x 3-1/2 inches) and flange nut (3/8 inch) from the control arm
5. Remove the hex-head bolt (1/2 x 2-1/4 inches) and locknut (1/2 inch) securing the strut assembly to
the upper frame
6. Remove the strut assembly
Note:
Repeat this procedure for the other side of the machine.
1. Hex-head bolt (1/2 x 2-1/4 inches)
2. Locknut (1/2 inch)
3. Collar
4. Spring
5. Strut assembly
(Figure 1).
(Figure 1).
Figure 1
6. Flange nut (3/8 inch)—from the control arm
7. Flange nut (3/8 inch)—from the spindle
8. Hex-head bolt (3/8 x 3-1/2 inches)—from the control arm
9. Hex-head bolt (3/8 x 4-3/4 inches)—from the spindle
5
(Figure 1).
(Figure 1).
g206327