DIVAR IP all-in-one 7000 2U
1.
2.
3.
4.
4.4
Turning on the system
To turn on the system:
1.
2.
Bosch Security Systems B.V.
Determine how far the chassis will extend out the front of the rack.
Put larger chassis so that the weight between front and back is balanced.
If a bezel is included on the chassis, remove it.
Attach one L-shaped bracket to each side of the chassis front and one L-shaped bracket
to each side of the chassis rear.
Make sure that the brackets are positioned with just enough space to fit the width of the
Telco rack.
Slide the chassis into the rack and tighten the brackets to the rack.
Plug the power cord from the power supply unit into a high-quality power strip that offers
protection from electrical noise and power surges.
Bosch recommends to use an uninterruptible power supply (UPS).
Push the power button on the control panel to turn on the system.
Installation manual
Rack installation | en
23
2021.03 | V2 | DOC