Table of Contents

Advertisement

SETUP

WARNING:
and understand entire Safety section
before proceeding
NOTICE: Refer to Controls and Features on
page 11 during setup.
1. Remove packaging and unit from
container.
2. Unlock and lower operator platform into
operating position (see To Move the
Operator Platform on page 17).
3. Open bypass valves (see To Push The
Unit on page 17).
4. Push unit onto a level surface.
5. Close bypass valves.
6. Check tire pressures (see Specifications
on page 38).
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a tire
without the proper equipment and
experience to perform the job.
• Do not inflate the tires above the
recommended pressure.
• Do not stand in front or over the
tire assembly when inflating. Use
a clip-on chuck and extension
hose long enough to allow you to
stand to one side.
7. Clip cable tie and remove wrap from
steering levers.
8. Check steering lever positions (see
Steering Lever Adjustment on page 26).
9. Remove battery from unit and charge
(see Battery on page 25).
10. Check engine oil level and add if needed
(see engine manual).
11. Check hydraulic fluid level and add if
needed (see Check Hydraulic Fluid Level
on page 22).
12. Fill engine fuel tank with clean fuel (see
Filling Fuel Tank on page 15).
IMPORTANT: See engine manual for fuel
type.
13. Inspect all hardware and tighten if loose.
AVOID INJURY. Read
.
14. Check safety interlock system functions
(see Safety Interlock System on
page 12).
WARNING: FAILURE OF
INTERLOCK together with
improper operation can result in
severe personal injury.
15. Lubricate all fittings (see Maintenance
Schedule on page 19).
16. Place discharge chute in the operating
position.
17. Check that mower deck is level per
factory standards (see Leveling the
Mower Deck on page 33).
18. Check all control functions and ensure
unit operates properly (see Controls and
Features on page 14).
WARNING: FAILURE OF
CONTROLS could result in death
or serious injury.
EN - 10

Advertisement

Table of Contents
loading

Table of Contents