Setup - Gravely pro-stance 36 994131 Operator's Manual

SETUP

WARNING:
and understand entire Safety
Section before proceeding.
NOTICE: Refer to Controls And Features on
page 11 during setup.
1. Remove packaging and unit from
container.
2. Open bypass valves (Item 1 and Item 2)
(see To Push The Unit on page 17).
3. Push unit onto a level surface.
4. Close bypass valves.
5. Check tire pressures (see Specifications
on page 38).
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when serviced incorrectly:
• Do not attempt to mount a tire
without proper equipment and
experience to perform the job.
• Do not inflate tires above
recommended pressure.
• Do not stand in front or over the
tire assembly when inflating. Use
a clip-on chuck and extension
hose long enough to allow you to
stand to one side.
6. Unlock and lower operator platform
(Item 3) into operating position (see To
Move the Operator Platform on
page 17).
7. Clip cable tie and remove wrap from
steering levers.
8. Check steering lever positions (Item 4)
(see Steering Lever Adjustment on
page 26).
9. Remove battery (Item 5) from unit and
charge (see Battery on page 25).
10. Check engine oil level and add if needed
(see engine manual).
11. Check hydraulic fluid level and add if
needed (see Check Hydraulic Fluid
Level on page 21).
12. Fill engine fuel tank (Item 6) with clean
fuel (see Filling Fuel Tank on page 15).
IMPORTANT: See engine manual for fuel
type.
13. Inspect all hardware and tighten if loose.
AVOID INJURY. Read
14. Check safety interlock system functions
(see Safety Interlock System on
page 14).
WARNING:
INTERLOCK together with improper
operation can result in severe
personal injury.
15. Lubricate all fittings (see Maintenance
Schedule on page 18).
16. Place discharge chute in the operating
position. Return and tighten knob in
original position on deck for storage
(Figure 3).
Operating Position
17. Check that mower deck (Item 9) is level
per factory standards (see Leveling the
Mower Deck on page 31).
18. Check all control functions and ensure
unit operates properly (see Controls And
Features on page 12).
WARNING: FAILURE OF
CONTROLS could result in death or
serious injury.
EN - 10
FAILURE OF
Transport Position
Figure 3