Sony ShowView HV-FX7950N Operating Instructions Manual page 2

Table of Contents

Advertisement

ENGLISH
WARNING
To prevent fire or shock hazard, do not expose the unit to
rain or moisture. To avoid electrical shock, do not open
the cabinet. Refer servicing to qualified personnel only.
Precautions
Safety
• This unit operates on 200-240 V AC, 50 Hz. Check that the
unit's operating voltage is identical with your local power
supply.
• If anything falls into the cabinet, unplug the unit and have it
checked by qualified personnel before operating it any
further.
• The unit is not disconnected from the mains as long as it is
connected to the mains, even if the unit itself has been turned
off.
• Unplug the unit from the AC outlet if you do not intend to use
it for an extended period of time. To disconnect the cord, pull
it out by the plug, never by the cord.
• To prevent fire or shock hazard, do not place objects filled
with liquids, such as vases, on the apparatus.
Installing
• Allow adequate air circulation to prevent internal heat buildup.
• Do not place the unit on surfaces (rugs, blankets, etc.) or
near materials (curtains, draperies) that may block the
ventilation slots.
• Do not install the unit near heat sources such as radiators or
air ducts, or in a place subject to direct sunlight, excessive
dust, mechanical vibration or shock.
• Do not install the unit in an inclined position. It is designed to
be operated in a horizontal position only.
• Keep the unit and cassettes away from equipment with strong
magnets, such as microwave ovens or large loudspeakers.
• Do not place heavy objects on the unit.
• If the unit is brought directly from a cold to a warm location,
moisture may condense inside the VCR and cause damage
to the video head and tape. When you first install the unit, or
when you move it from a cold to a warm location, wait for
about 3 hours before operating the unit.
2
ENGLISH
Caution
Televison programs, films, video tapes and other materials
may be copyrighted. Unauthorized recording of such material
may be contrary to the provisions of the copyright laws. Also,
use of this recorder with cable television transmission may
require authorization from the cable television transmitter
and/or program owner.
ShowView is a registered trademark of Gemstar Development Corporation.
The ShowView system is manufactured under licence from Gemstar
Development Corporation.

Advertisement

Table of Contents
loading

Table of Contents