SATO CX400 Programming Reference Manual page 27

Section 2: Command Codes
Special Notes
SATO CX400
1. Use of this command will set the Vertical/Horizontal Offset setting of
the printer configuration until a new Base Reference Point command
is issued or the setting is changed from the operator panel.
2. This command may be used more than once in a print job.
3. An alternative to using this command is to make changes to your cur-
rent Horizontal and Vertical Print Position commands.
Example: Let us say the current base reference point is H=1, V=1 and
you wish to move all the fields on your label downward vertically by
150 dots. You could either (1) add the Base Reference Point
command or (2) change all the vertical position commands by an
additional 150 dots.
4. For a more detailed example of the Base Reference Point command,
see Section 1. Print Area.
5. The CX400 print engines can print as close as 2 mm to the inside
edge of the label.
6. The printers will not "wrap" (i.e. if any part of a character or image
extends beyond the last print dot position, it will disappear and not be
visible on any part of the label).
PN 9001106 Rev. A Page 2-11