Master Mistral Compact Manual page 13

- Keep press the button "2" on the anemometer sensor body, power the central.
The red led begins to flash speedly.
- Keep press the button "2" for about 30 sec, since the motor effects 1 upward
movement and one downward to indicate the restore of factory conditions (both
the led are switch on).
- Take off tension to the central and expect few seconds.
- Give again tension to the central.
9. EXPIRED
At the end of the cycle of the product, dispose as provided by local reg-
ulation. This product can be contain polluting substance for the environ-
ment and dangerous for health, is forbidden dispose the product with the
domestic waste.
10. FAQ AND PROBLEMS SOLUTION
? The central unit doesn't execute any operation.
- Check that the central is correctly power (between terminals N and L have to
result apply the network tension).
- As soon as is power, the central switch on shortly the 2 led to signal that the sup-
ply is regularly receipt to the central. If that couldn't happen, is probably the pres-
ence of irreversible failure and could be necessary the replacement of the cen-
tral unit.
? When press UPWARD of transmitter, the motor moves in downward.
- Take off supply to the central and reverse the wires to the terminals D1 and S1.
? When try to memorize the first transmitter, the motor does 2 downward
movements.
- Make sure to correctly have performed the procedure of memorization (point
5.1).
- The procedure has too slowly been execute. From the moment which the central
enters in "transmitter programmation" there are 8 sec for pressing the button
Stop of the transmitter to memorize.
- Verify that the batteries of the transmitter are loaded.
- Try to effect the same operation with another transmitter.
- Check that the environment is not disturbed from other devices working at the
same frequency (for example earphones, alarms, etc).
- Effect a reset of the system (point 8) and try again to insert the transmitter.
- The receiver of the central unit could be demage and could be necessary the
substitution of the central unit.
? When try to memorize further transmitter, the motor efects 2 movements
downward.
- Check that the transmitters memorized yet working correctly.
- Be sure to have correctly execute the procedure of memorization (point 7.1).
- The procedure of memorization was execute too much slowly. At moment that
the central entries in "transmitter programmation" there are 8 sec to press the
button STOP of the transmitter to memorize.
- Check that the batteries of transmitter to memorize are loaded.
? When try to memorize a transmitter, the motor does 1 upward movement
and 3 downward movements.
- The central unit signals that it has memorized yet the top numbers of 15 trans-
mitters, the memorization of further transmitter is not allowed.
? When try to cancel one transmitter from the memory, the motor does 2
downward movements.
- Be sure to have correctly execute the procedure of cancellation (point 7.2).
- The operation was execute too much slowly. At moment that the central unit
entries in " transmitter programmation" there are 8 sec to press the button STOP
MISTRAL COMPACT_rev00 13