First Installation - Master Mistral Compact Manual

- Do not modify or replace parts without autorization of the head office.
- Connect the motor with ground wire.
- Adjust the limit switch of the motor before connect it to the system.
- For your safety, is forbidden working near the roller tube when the motor is pow-
ered.
- Be sure that the central unit had been installed in good expose for the wind with-
out obstacles for movement of blades rotation of the wind sensor.
- To verify the correct connection between motor and central unit, bring the
awning in intermediate position and check that the wind alarm starts up the
motor in upward.
3.1 Supply
The central MISTRAL COMPACT/60.001.110 can be supply by tension of 120 Vac
or 230 Vac and frequency 50/60 Hz. The tension of supply can be apply at termi-
nals L and N.
3.2 Connection with motor
The common wire of the motor has to be connected to the terminal N, the wrap-
pings of the motor have to be connected with terminals D1 and S1. When all the
connections are finished, bring the awning in intermediate position and check that
the wind alarm starts up the motor in upward (if the motor moves in downward,
reverse the wires at the terminals D1 and S1). Is forbidden connecting more than
one motor directly to the central without using the suitables modules of expansion
(for example the modules of expansion X52/60.002.003, X54/60.002.004 or equiv-
alents).
4. COMPATIBLE TRANSMITTERS
4.1 Portable transmitters
The central MISTRAL COMPACT/60.001.110 is compatible with all the transmit-
ters of serie OTELLO/60.003.001, VECTOR/60.003.11 and equivalents and it can
hold since 15 different radio codes in memory.
OTELLO
60.003.001
Up
Stop
Down
4.2 Radio General Sensors
The central MISTRAL COMPACT/60.001.110 is compatible with some general
radio sensor product by this head office. The memorization of radio sensor is like
a normal transmitter (see point 7.1). Where provided, the operation threshold can
be programm directly on radio sensor. For more detail informations see the
instruction of radio sensor.

5. FIRST INSTALLATION

5.1 Memorization of 1° transmitter
Keep press the button "1" on the anemometer body for about 4 sec since the
motor effects two upward movemets to signal the entry in menu "transmitter pro-
10
Series
Prog
Series
VECTOR
60.003.011
Up
Stop
Down
MISTRAL COMPACT_rev00
Prog