Master Mistral Compact Manual page 11

grammation". Th yellow led is switch on, than issue the button.
Within 8 sec, press STOP of the portable transmitter to insert in memory. Before
turn back to the normal activity, the central signals the acquisation of the code
with a upward movement of the motor.
5.2 Memorization of further transmitters
The procedure describes at point 5.1 can be use for insert further transmitters
(since the maximum of 15), all the same is possible done this operation more com-
fortable, using a transmitter memorized yet, as describe at point 7.1.
6. LOGIC OF WORKING OF WIND SENSOR
If the intensity of the wind is superior to the programmed threshold at almost 3
seconds, is execute a manouvre of upward to protect the awning (wind alarm).
During this phase all the manual commands are inhibits. The central exits to the
situation of "wind alarm" if at least 8 minutes the intensity of wind is under the pro-
grammed threshold. The wind threshold is variable at 10 at 35 Km/h. The factory
programs the wind threshold at 15 Km/h (threshold 2). The wind threshold can be
modify using any portable transmitter memorized in the central, as describe at
point 7.3.
6.1 Visual Signalationes regarding wind sensor
The red led provides some signalationes regarding wind sensor:
- The red led is switch on fixed: the wind velocity is superior to the programmed
threshold; if this condition remains at least 3 sec the central will entry in the con-
dition of "wind alarm".
- The red led is flashing speedly: the central is in wind alarm, all the commands are
inhibits.
- The red led is switch off: the wind velocity is under the programmed threshold.
6.2 Forced exit from wind alarm
During the installation of the central is posible exit from the wind alarm without
expect 8 minutes provided, keep press the button "2" on the anemometer body
for about 5 sec, since the red led is switch off.
6.3 Function " anemometer test "
If active, the central effects a test on the wind sensor working. If for about 24 hours
the wind sensor doesn't produce any valid impulse, the central forces the upward
of the awning kierkly, suspend any other activity and signal the anomaly switching
on the two leds. The device will exit from this state brining back the normal activ-
ity only when it will reach a valid impulse from the anemometer. Is posible acti-
vate/desactivate the function "anemometer test" using a portable transmitter
memorized in the central. The procedure of activate/desactivate of "anemometer
test" is describe in the transmitter instruction at point "anemometer test function".
6.4 "Automatic downward" function
If the function is active and if the last manouvre effect before the entry in wind
alarm was a downward, when it exits from wind alarm the central orders as down-
MISTRAL COMPACT_rev00
Button 2
11