KTM 350 SX-F 2020 Owner's Manual page 94

12 BRAKE SYSTEM
92
–
Manually press the brake caliper toward the brake disc to push
back the brake piston. Ensure that brake fluid does not flow
out of the brake fluid reservoir, if necessary extract excess.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake piston.
–
Remove cotter pins
brake linings.
F00155-10
–
Clean the brake caliper and the brake caliper bracket.
–
Check that spring plate
6
plate in the brake caliper bracket are seated properly.
Info
The arrow on the spring plate points in the direction of
rotation of the brake disc.
S01251-10
–
Insert the new brake linings, insert pin
3
pins .
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
piston side brake lining.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
H00025-10
point.
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
O-ring.
Info
Immediately clean up any brake fluid that has over-
flowed or spilled with water.
F01546-10
3 4
, pull out pin , and remove the
5
in the brake caliper and sliding
4
, and mount cotter
7
is mounted on the
A
.
p. 137)
1
with membrane
2
and the