13 WHEELS, TIRES
96
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal rings
of the spacers.
Long-life grease (
–
Insert the spacers.
H03001-10
–
Clean and grease the wheel spindle.
Long-life grease (
–
Position the rear wheel and insert wheel spindle
The brake linings are correctly positioned.
–
Mount the chain.
V00297-10
–
Position chain adjuster
it yet.
–
Make sure that chain adjusters
adjusting screws
–
Check the chain tension. (
–
4
Tighten nut
Guideline
Nut, rear wheel spin-
dle
Info
The wide adjustment range of the chain adjusters
(32 mm (1.26 in)) enables different secondary ratios
with the same chain length.
Chain adjusters
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
V00298-10
Finishing work
–
Remove the motorcycle from the lift stand. (
1
and contact surfaces
p. 139)
p. 139)
3
4
. Mount nut
, but do not tighten
3
are fitted correctly on
5
.
p. 73)
.
M25x1.5
80 Nm (59 lbf ft)
3
can be turned by 180°.
A
2
.
p. 49)