Table of Contents
Advertisement
Installation
Refer to section: 'Important Safety Information' first.
This installation covers all models of the Mira Advance ATLP Thermostatic
shower.
1. Electrical supply is
turned off at the mains.
4. Remove front cover.
Determine supply pipe
position.
7. Flush a minimum of
10 litres (2 gallons)
through pipework prior
to connection.
2. Determine the shower
p o s i t i o n , l e a v i n g
adequate space for
maintenance.
5. Turn inlet connector to
suit supply pipe.
Do not trap green
(earth) wires.
8. Caution! Do not drill
into buried cables or
pipes.
13
200 mm
3. Remove cover screws.
6. C o m p l e t e
soldering required
away from appliance.
Required
Fixing Hole
1173258-W7-A
9. Use template provided
t o m a r k a n d d r i l l
required fixing holes.
Screws and plugs are
supplied for 4 holes.
a n y
100 mm
Required
Fixing Hole
Determine the shower
Mira Advance ATL Low Pressure
p o s i t i o n , l e a v i n g
adequate space for
Attention Installer
maintenance.
IMPORTANT!
The following key details should be read in
conjunction with the Installation and User Guides.
Do not install the appliance where it
may become frozen.
Do not drill into buried cables or
pipes.
Avoid dust contamination of the
product by using this template to mark
and drill into the wall. Drill appliance
case separately.
Do not use alternative screws to
secure the cover.
Do not seal any part of the appliance.
pipework before connecting
to the appliance.
Use the correct supply cable
size. Refer to BS 7671.
For technical support and general enquires,
spare parts and after sales service contact us on:
Telephone : 0870 241 0888
Required
Fax :
01242 282 595
Fixing Hole
email :
technical@mirashowers.com
(if using 4 screws)
Required
Required
Fixing Hole
Fixing Hole
(if using 4 screws)
(if using 3 screws)
© Kohler Mira Limited, June 2011
Advertisement
Table of Contents
