Speaker Modeling - Roland VS-2480 Supplementary Manual

Speaker Modeling

Models a variety of speaker characteristics ranging from those of High-end professional monitor speakers used
as the standard at studios around the world to those of speakers of small-sized TV sets and portable radios.
fig.08-81
Input L
SP Modeling
SP Modeling
Input R
• Speaker Modeling is adjusted so that its optimal effect is achieved when a Roland Powered Monitor DS-90 is
used in digital connection. Its effect may not be fully achieved with other types of speakers.
• "Mic Modeling" cannot be used on the projects with 64kHz or higher sampling rate.
Speaker types applicable for modeling
The characteristics of the following types of speakers can be modeled. Set the desired type for Model.
THRU:
Super FLAT:
Powered GenBlk:
Powered E-Bas:
Powered Mack:
Small Cube:
White Cone:
White C +tissue:
Small Radio:
Small TV:
Boom Box:
BoomBox LoBoost:
* Use "THRU" for clear comparison between sounds with and without modeling.
BassCut Freq Lo Freq Trim
BassCut Freq Lo Freq Trim
No modeling is to be performed.
DS-90 is corrected by modeling to produce wider-range and untwisted sounds.
Typical model of powered monitor (two-way type, the woofer diameter = 170 mm (6-1/
2 inches))
Powered monitor characterized in delightful sound quality
Powered monitor characterized in well-extended low frequency band sounds
Small-sized full-range speaker widely used in recording studios
Enclosed-type two-way speaker widely used in recording studios, characterized in
white woofers.
Mild sounds from "White Cone" Tweeter covered with tissue paper
Pocket-type small-sized radio
Speaker attached to the 14-inch TV set
Radio cassette recorder
Radio cassette recorder with the low frequency band enhanced
Algorithm List
Hi Freq Trim Limiter
Hi Freq Trim Limiter
Output L
Output R
Continued...
83