Table of Contents
Advertisement
Figure 15
LUBRICATE AUGER SHAFT
1. Remove shear bolt nuts and bolts. See
Figure 16.
Figure 16
2. Apply grease at the grease zerks. See
Figure 17.
Figure 17
3. Hand rotate auger on auger shaft.
4. Align shear bolt holes in auger with shear
bolt holes in shaft.
5. Insert bolts through holes.
6. Secure bolts with nuts.
7. Tighten bolts to 7.9 N•m – 16.5 N•m
(5.8 lb-ft – 12.2 lb-ft). If a torque wrench is
unavailable, tighten bolts until they no
longer spin freely. DO NOT overtighten.
CHARGE BATTERY
IMPORTANT: Snowblower charges battery
when in use if at "Efficiency" or higher engine
speed.
1. Disconnect battery connector. See
Figure 18.
IMPORTANT: Battery charger is shipped in
the literature pack.
EN - 15
Figure 18
Advertisement
Table of Contents
