Service And Adjustments; General Lubrication; Auger Shaft; Scraper Blade - Ariens 920402 – Sno-Tek 24E Owner's/Operator's Manual

Hide thumbs Also See for 920402 – Sno-Tek 24E:
Table of Contents

Advertisement

GENERAL LUBRICATION

(Figure 12)
IMPORTANT: Wipe each fitting clean before
and after lubrication. Do not wipe gearcase
filler plug; wiping the gearcase filler plug may
remove thread sealant and cause leaks.
IMPORTANT: DO NOT allow grease or oil to
get on friction disc, friction plate or belts.
NOTE: Apply Ariens Hi-Temp Grease or
equivalent to the lubrication fittings. See
SERVICE PARTS on page 28.
The unit should be lubricated (Figure 12) at
beginning of season or every 25 operating
hours.

Auger Shaft

NOTE: To grease auger shaft, remove shear
bolt nuts, and shear bolts. Apply grease at the
grease zerks and then turn the auger
assemblies on the auger shaft. Replace
shear bolts per instructions in Shear Bolts on
page 20.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.

SCRAPER BLADE

IMPORTANT: Damage to auger/impeller
housing will result if blade wears down too
far.
Scraper blade is adjustable to compensate
for wear.
To adjust scraper blade:
1. Tip unit back onto handlebar, support
housing and loosen nuts retaining blade.
2. Adjust skid shoes to fully raised position
(housing closest to ground).
3. Reposition scraper blade flush with skid
shoes and tighten lock nuts.

SERVICE AND ADJUSTMENTS

Grease

SKID SHOES

(Figure 13)
Skid Shoes should be adjusted as conditions
require.
1. Position unit on a hard, flat, smooth level
surface.
2. Adjust skid shoes by inserting a spacer
of desired thickness under center of
scraper blade, loosen skid shoe
hardware, slide skid shoes to flat
surface. Allow 1/8 in. (3 mm) between
scraper blade and hard smooth
surfaces. Allow 1-1/4 in. (30 mm)
between scraper blade and uneven or
gravel surfaces. Retighten hardware.
NOTE: Keep housing level by adjusting skid
shoes equally.
GB - 19
Oil
Figure 12
OS8051

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

920403Sno-tek 24eSno-tek 28e

Table of Contents