Table of Contents
Advertisement
2
1
1. Auger Gearcase Cover
2. Oil Fill Plug
3. Seal Washer
Figure 19
3. Check oil level with dipstick and add oil if
needed. Oil level must be 6.1 – 6.7 cm
(2.4 – 2.6") from the flat surface of the
gearcase cover.
IMPORTANT: Ariens recommends using only
Ariens L3 synthetic severe duty gear lube
(see Service Parts on page 14). Using other
lubricants will not automatically void unit
warranty, but the warranty will not cover
damage caused by using unauthorized
lubricants.
4. Inspect seal washer for wear or rubber
deterioration and replace if needed.
5. Reinstall seal washer (rubber side down)
and oil fill plug. Torque to 9 N•m
(80 lb-in).
IMPORTANT: DO NOT over torque.
Measurements are given in pound force
inches (lb-in) and not pound force foot (lb-ft).
IMPORTANT: Incorrect torquing and failure to
install or correctly torque seal washer may
void gearcase warranty.
LUBRICATE UNIT
Ariens recommends using Ariens Hi-Temp
Grease or equivalent (see Service Parts on
page 14) to lubricate fittings. Lubricate each
season or every 25 hours of operation.
IMPORTANT: Wipe each fitting clean before
and after lubrication.
Remove Bottom Cover
Models 926066, 926072
1. Place unit in service position (see
Figure 18).
2. Remove six hex bolts retaining cover and
remove cover. Save for reinstallation.
Model 926067
See Figure 20.
1. Place unit in service position (see
Figure 18).
3
2. Remove three top-lock flange nuts
retaining height-adjuster plate to height-
adjuster bracket.
3. Remove height-adjuster plate and three
spacers on the round head square neck
bolts. The height-adjuster stop will be
attached to the rear axle.
4. Slide height-adjuster stop to the right and
rotate it away from frame.
NOTICE: The track carriage will rotate freely
without the height-adjuster bracket. Keep
fingers and hands away from pinch points.
5. Remove six bolts retaining bottom cover
and remove cover. Rotate track carriage
as needed to remove cover.
3
1. Top-lock Flange Nut
2. Height Adjuster Plate
3. Height Adjuster Stop
4. Bottom Cover
5. Rear Axle
EN - 15
2
4
1
5
Figure 20
Advertisement
Table of Contents
